Nissan Bags


Custom Wheel tubs	Tubular Upper and lower Arms Dropped spindles All pieces powdercoated	Clutch protector bump	Clutch master area

Mounting point for engine compartment electronics	Powder coated Tubular upper and lower arms Airbags Custom shock mount Frame and upper bag mounts cleaned and painted	Custom Shock Mounts Frame cleaned and painted	Front suspension is completed and reassembled Slotted and drilled Rotors added

	Notches in place Frame plated	Air tanks Mounted Compressor mounts in 4 link tacked in	Always checking measurements

Adjusting upper mounts on the frame for proper geometry	Rear end removed for finish welding	Airbag upper supports finished	Compressors mounted and lines run

Rear half ready for paint	Tubing clearanced for fitting and boxed back in.	Custom stock floor progressing	Tubs in floor progressing

	Floor raised	Floor completed	Battery tucked under the floor

Disassembled for painting	Tanks and compressors back in.	Underside of the bed coated	Area under compressors and tanks protected by plate

Rear end and link bars reinstalled	Lines complete	Rear suspension complete	Custom Fuel cell filler

Bed flared and gas door shaved	Showing the bed widening	Fuel cell will be in front of the axle	Truck aired up

	Newer Pathfinder dash installed	Loading up and off to the paint shop	Back from Paint. Time for reassembly

Engine compartment painted	Custom bedfloor	Paint came out nice. After we are done it goes back for a final buff and detail	Front end assembly underway

All the pieces laid out for assembly	Driver side painted. Clutch master in place	Another shot of the driver side.	Passenger side painted

Suspension reassembled and brakes complete	Almost ready to ship	Battery wired up with fuse blocks	Ready to drive